Instructions / Assembly

9
II
8. Remove reector panels (A) and reector plate (B) from
packaging.
WARNING: Remove protective plastic cover before
assembling.
9. Slide two reector panels (A) together. Insert one screw
M6 x 10 (ll). Slide one washer
6 (HH) over the threaded
end of screw M6 x 10 (ll) and screw on one M6 cap nut
(JJ) loosely. Attach the third panel on both sides to the two
already joined panels using two more M6 x 10 screws (ll),
two more
6 washers (HH), and two more M6 cap nuts
(JJ).
Note: For proper alignment of reector panels, keep bolts
loose until all parts are together and then tighten.
10. Slide reector plate (B) onto reector panels (A). Insert
one screw M6 x 10 (ll). Slide one washer
Φ 6 (HH) over
threaded end of screw M6 x 10 (ll) and screw on one
M6 cap nut (JJ) loosely. Repeat procedure to complete
the assembly of all three sections. Fully tighten all of the
screws in the rolled edge.
8
ASSEMBLY INSTRUCTIONS
A
B
A
JJ
HH
II
Hardware Used
II
x 3
x 3
HH
JJ
Washer Φ 6
Screw M6 x 10
M6 Cap nuts
x 3
9
Hardware Used
II
x 6
x 6
HH
JJ
Washer Φ 6
Screw M6 x 10
M6 Cap nuts
x 6
10
II
JJ
HH
II
A
B