Instructions / Assembly

8
5. Load Cylinder Housing (D) onto Post (E).
Slide Cylinder housing (D) down.
ASSEMBLY INSTRUCTIONS
5
D
E
6. Attach three reector spacers (FF) and three washers 8
(GG) to screen cover on the head assembly (C). Tighten
the reector spacers (FF).
Hardware Used
FF
x 3
x 3
GG
LL
Washer Φ 8
Reector Spacer
Wrench
7. There should be 4 stainless steel bolts M6 x 10 (DD)
already assembled to the head assembly (C). Remove
these stainless steel bolts (DD) and set them aside. Load
the head assembly (C) by inserting the hose into the post
(E). Insert the head assembly (C) into the post (E). Attach
the head assembly (C) to post (E) by loosely installing the
four stainless steel bolts M6 x 10 (DD) previously removed.
Tighten bolts securely.
DD
LL
Bolt M6 x 10 x 4
Wrench
Hardware Used
6
FF
GG
C
NOTE: If you purchased a separate table
accessory, please refer to that manual
now. If you do not refer to that manual at
this time you will have to disassemble the
unit in order to add the table accessory.
C
E
DD
DD
6
7