Instructions / Assembly

7
ASSEMBLY INSTRUCTIONS
1. To improve the stability, the base (G) must be lled with sand.
Remove lid from center of base (G). Slowly pour the sand
into the base (G). Shake the base (G) to disperse the sand
evenly. Close lid tightly.
2. Attach Wheel Assembly (H) to base (G). Wheel assembly (H)
already has two bolts M8 x 16 (BB) and two M8 ange nuts
(AA) pre-assembeled. Unscrew these (BB) bolts from these
(AA) nuts. Line up the holes in the wheel bracket (H) with
the corresponding holes in the base (G). Insert the two bolts
M8 x 16 (BB) through the holes, and nger tighten with two
M8 ange nuts (AA). Be sure that the wheel assembly (H) is
parallel to the base (G), and fully tighten the bolts.
Hardware Used
1
Fill sand
3
Bolt M6 x 30
M6 Flange Nut
4
BB
G
G
Hardware Used
3. Loosely attach three support brackets (F) to base (G) with
three bolts M8 x 16 (BB) downward through support brackets
(F) into the base (G).
Bolt M8 x 16
BB
AA
BB
H
x 3
Wrench
LL
F
F
G
E
EE
CC
G
4. Attach post (E) to three support brackets (F) using six bolts
M6 x 30 (EE) and six M6 ange nuts (CC). Fully tighten all of
the screws, including those at the base (G).
Hardware Used
CC
x 6
x 6
EE
Wrench
LL
1
1
2
3
4
Bolt M8 x 16
BB
x 2
M8 ange nuts
AA
x 2
Wrench
LL