Instructions / Assembly

Caution: Do not attempt to operate until you have read and understand all General Safety Information in this

manual and all assembly is complete and leak checks have been performed.

Before Turning Gas Supply ON:

1. Your heater was designed and approved for outdoor use only. Do NOT use it inside a building, garage, or

any other enclosed area.

2. Make sure surrounding areas are free of combustible materials, gasoline, and other ammable vapors and

liquids.

3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and there are no

leaks.

4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or servicing

is replaced and fastened prior to starting.

Before Lighting:

1. Heater should be thoroughly inspected before each use, and by a qualied service person at least annually.

If relighting a hot heater, always wait at least 5 minutes.

2. Inspect the regulator and hose assembly (RR) for evidence of excessive abrasion, cuts, or wear.

Suspected areas should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use

the replacement regulator and hose assembly (RR) specied by manufacturer.

Lighting:

Note: This heater is equipped with a pilot light that allows for safer startups and shutdowns. Pilot must be lit

before main burner can be started.

1. Turn the control knob to the “OFF” ( O ) position.

2. Fully open LP cylinder valve.

3. Open viewing hole by sliding cover to either side (Figure 1).

CAUTION: Do not touch or move this part while the unit is in operation. Unit is hot when operating.

Always use a tool to slide the cover open.

4. Push control knob in and rotate counter clockwise to “PILOT” (

) position (Figure 2).

Note: For initial start or after any cylinder change, hold control knob in for no more than 2 minutes or until

you smell gas to purge air from gas lines before proceeding.

OPERATION INSTRUCTIONS

DANGER

• CARBON MONOXIDE HAZARD

• For outdoor use only. Never use inside

building, garage, or other unventilated or

enclosed areas. This heater consumes air

(oxygen). Do not use in unventilated or

enclosed areas to avoid endangering your life.

Figure 1 Figure 2