Use and Care Manual

ASSEMBLY INSTRUCTIONS

CHECKING FOR LEAKS

After all connections are made, check all connections and ttings on the natural gas quick connector,

gas hose and manifold for leaks with a water and soap solution.

To prevent re or explosion while testing for a leak:

• Always perform leak test prior to lighting the grill.

• Do not smoke while testing for a leak.

• Always perform leak tests outdoors in a well-ventilated area.

• Do not use any source of ame while testing for leaks.

• Do not use the grill until any and all leaks are corrected.

• If you are unable to correct a leak, close the natural gas shut-off and call a gas appliance service

agency.

PERFORM LEAK TEST

• Prepare leak test solution by combining 1 part liquid dish soap with 3 parts water.

Total solution required is approximately 2 - 3 ounces (70 - 90 ml).

Put leak test solution in a spray bottle.

• Ensure all control knobs are in the ‘OFF’ position.

• Connect the gas hose to the gas supply.

• Open the gas shut-off valve.

• Spray leak test solution on all gas carrying connections and ttings. Presence of bubbles at areas

of applied test solution indicates a gas leak. If leaks are detected or you smell or hear gas, shut off

the gas supply valve immediately and repair or replace the defective part. Do not use the grill until all

leaks are corrected.

ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO

PREVENT FIRE, DAMAGE AND/OR INJURY.

In the connection process, make sure:

• The gas supply hose does not come in contact or remain in contact with the rebox.

Only use the hose assembly provided! If a replacement is necessary, please call

our customer service center. Do not use replacement parts that are not intended for this grill.

WARNING

CAUTION