Use and Care Manual

OPERATION INSTRUCTIONS

Lighting The Grill

Before rst use:

Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important

to clean your grill with heat. To do this, operate the grill for approximately 15 minutes with the lid closed

and the control knob in the highest position. This will clean the internal parts by burning off any residue

and odor from the manufacturing process.

WARNING

Do not lean over grill when lighting. Read instructions before lighting. Do not put pots on the

sear side burner. Using pots on the sear side burner will result in high carbon monoxide levels.

CAUTION

If the ame extinguishes accidentally during ignition or operation, immediately TURN OFF the

cylinder valve and then TURN OFF the control knob.

1. Check that the control knobs are in the O OFF position.

2. Open the tank valve fully by turning it counter-clockwise.

3. Open lid during the lighting process.

4. Depress and turn control knob counter-clockwise from the O OFF position, past the

ignite

position, to the

HIGH position. You many need to repeat several times to ignite the burner.

If ignition does not occur in 5 seconds, turn the control knob(s) to

OFF position, wait 5 minutes, and

repeat the lighting procedure.

If the burner still does not light, check that there is gas in the cylinder and follow the match lighting

instructions. Check the Troubleshooting Guide on page 26 for more information.