Use and Care Manual

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
11
F.) FUEL LINES
TIGHTENING FUEL LINES ANNUALLY OR AS NEEDED.
- Remove upper shell (See page 9).
- Remove fan guard (See Figure 11)
- Use 1/4” wrench and tighten fuel lines(A) at solenoid valve
and at pump. (See Figure 12)
- Use 3/8” wrench and tighten fuel lines (B) at pump, pump fuel filter assembly.
- Reinstall fan guard.
E.) PHOTOCELL
CLEAN PHOTO CELL ANNUALLY OR AS NEEDED.
- Remove upper shell(See Page 9)
- Remove photocell from photocell Bracket and disconnect photocell from connector.
- Clean photocell lens with cotton swab.
- Inspect photcell lens for damage. If damaged, replace photocell.
PHOTOCELL BRACKET
PHOTOCELL LENS
INSTALL PHOTOCELL
1)INCORRECT
2)CORRECT
PHOTOCELL
CONNECTOR
FUEL LINE(A)
FUEL LINE(B)
PUMP
FAN GUARD
SOLENOID VALVE
Figure 10. Clean photocell Lens
enil leuf nethgiT .21 erugiFdraug naF evomeR .11 erugiF