Label Maker User Manual

18
Caring for Your Labelmaker
Your labelmaker is designed to give you long and trouble-free
service, while requiring very little maintenance. Clean your
labelmaker from time to time to keep it working properly. Clean the
cutter blade each time you replace the label cassette.
To clean the cutter blade
Press in and hold
1. Dampen a cotton ball with alcohol.
2. Remove the label cassette.
3. Place the tip of a ball-point pen or
pencil on the black post as shown in
Figure 6, and press the post down.
Print head
Figure 6
4. While holding down the post, press and
hold the cutter lever to expose the cutter blade.
5. Release the post and clean both sides of the blade with the
cotton ball.
6. Release the cutter lever.
Ç You can also follow this procedure if the cutter blade becomes
lodged in the forward position and will not move.
LT Momentum AUS.indd 18 19-03-2007 09:13:42