User Guide
Table Of Contents
- About Your New Label Maker
- Getting to Know the Label Maker
- Getting Started
- Using Your Label Maker as a Local Printer
- Using Your Label Maker as a Network Printer
- About DYMO Label Software
- Label Maker Status
- Caring for the Label Maker
- Troubleshooting
- Documentation Feedback
- Environmental Information
- Safety Precautions for Lithium-Polymer Rechargeable Battery Pack
Copyright
© 2013 Sanford, L.P. All rights reserved.
No part of this document or the software may be reproduced or transmitted in
any form or by any means or translated into another language without the prior
written consent of Sanford, L.P.
Trademarks
DYMO, DYMO Label, and LabelManager are registered marks in the US and other
countries. All other trademarks are the property of their respective holders.
Certifications
This product is approved by CE Notified Body, CE0890; It complies with Directive
2006/95/EC, 2004/108/EC and 99/5/EC.
FCC Statement
Caution: The user is cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation of this device.
This equipment complies with IC RF radiation exposure limits set forth for an
uncontrolled environment. The antenna(s) used for this transmitter must be
installed and operated to provide a separation distance of at least 20 cm from all
persons and must not be collocated or operating in conjunction with any other
antenna or transmitter. Installers must ensure that 20 cm separation distance will
be maintained between the device (excluding its handset) and users.