Specifications

6 EC-Series Flood Lamps for UVCS-Series Conveyors
2000-EC
for use with UVCS-Series Conveyors
5000-EC
for use with UVCS SideCure™ Conveyors
5000-EC
for use with UVCS-Series Conveyors
Electrical
See General Specifications
Dimensions
(Lamp/Reflector
Assembly Housing)
10.5" W x 9.0" D x 7.5" H
[26.7 cm x 22.9 cm x 19.1 cm]
6.75" W x 6.75" D x 8.0" H
[17.2 cm x 17.2 cm x 20.3 cm]
6.75" W x 6.75" D x 7.0" H
[17.2 cm x 17.2 cm x 17.8 cm]
Weight
3.4 lbs. [1.5 kg]
2.7 lbs. [1.2 kg]
2.7 lbs. [1.2 kg]
Typical Output
Intensity at UV-A*
(320-395 nm)
75 mW/cm
2
225 mW/cm
2
225 mW/cm
2
* 2000-EC: Nominal intensity 2.1" below the Reflector; 5000-EC: Intensity 3" below bottom edge of Lamp/Reflector Assembly Housing. All measured with an
ACCU-CAL™ 50 UV Radiometer calibrated and traceable to NIST.
INSTALLATION AND SYSTEM INTERCONNECT
1. Place the 400 Watt UV Bulb into the Lamp/Reflector Assembly Housing
(Figure 11). Refer to the Bulb Replacement/Installation Section of this
manual.
2. Position the Power Supply so that there is free air circulation around the
sides. The Lamp/Reflector Assembly Housing should be mounted to a
Dymax Conveyor as described in the Conveyor's technical manual.
WARNING! Always observe safety requirements when working with
electrical equipment! Electrical hazard is present!
3. Connect the Interconnect Cable to the J3 Receptacle on the rear of the
Lamp/Reflector Assembly Housing (Figures 11-13).
4. Connect the opposite end of the Interconnect Cable to the Lamp Power
Receptacle (Figure 14) on rear panel of the Power Supply.
5. Plug the AC Power Cord into the Power Module located in the rear panel of the Power Supply (Figure 14),
and plug the opposite end of the AC Power Cord into appropriate external AC source.
Figure 12-13. Interconnect Cable in J3 Receptacle (From Left: 2000-EC Lamp/Reflector
Assembly for UVCS-Series Conveyors, 5000-EC Lamp/Reflector Assembly for SideCure™
Conveyors, 5000-EC Lamp/Reflector Assembly for UVCS-Series Conveyors
Figure 11. Bulb in Lamp/Reflector
Assembly Housing
Lamp Power Receptacle
Power Module
Figure 14. Power Supply, Rear Panel