Specifications

EC-Series Flood Lamps for UVCS-Series Conveyors 3
UNPACKING AND INSPECTION
Upon receipt of the unit, carefully remove the contents from the
boxes and check for damage. Dymax is not responsible for
damage from shipping – all claims for shipping damage should
be made with the carrier.
Check all boxes for contents and write down any serial numbers
for further reference. You may wish to retain original shipping
cartons in case you need to repackage any item for return.
If you observe or experience any problem with your equipment,
notify Dymax Customer Service, your authorized distributor, or
your Dymax Representative immediately.
NOTE: Report any shortage to Dymax Customer Service.
Before continuing with unpacking and installation, please read
the following chapters of this manual for safety recommendations
and installation, operation, and troubleshooting instructions.
GENERAL INFORMATION
Dymax Flood Lamps are designed for installation into Dymax UVCS-Series Light-Curing Conveyors. They have
extensive use in a wide variety of applications such as bonding, potting, sealing, and encapsulating. These Flood
Lamps are extremely unique in that they offer exceptional versatility and expandability.
Each unit is designed and shipped in a unitized configuration for easy bench-top mounting with all controls and
functions right at the hands of the operator.
The Lamp/Reflector Assembly Housing can be mounted side-by-side in a linear configuration on Dymax
Conveyors (Figure 4 & 5). The Power Supplies can then be stacked and mounted remotely to provide
consolidated operator control.
Figure 4. 2000-EC mounted side by side Figure 5. 5000-EC mounted side by side Figure 6. 5000-EC mounted on
on Conveyor on Conveyor Side Cure Conveyor
Figure 1. 5000-EC for UVCS Conveyor
Figure 2. 5000-EC for UVCS SideCure™
Conveyor
Figure 3. 2000-EC for UVCS Conveyor