User's Manual Part 2

19
WWW.DYEPAINTBALL.COM
HYPER5
™
GAS THRU REGULATOR
The M2 software tracks how many shots the marker has fired, and will
alert you when service is due. A red service icon will flash over the playing
screen. See service system on page 8 for more info.
NOTE: IT IS IMPORTANT TO KEEP THE SEAT AND PISTON FACE CLEAN OF ALL
DIRT AND DEBRIS. CLEAN THE SEAT AND PISTON FACE AND APPLY FRESH
GREASE EVERY 6 MONTHS OR 75,000 - 100,000 SHOTS, DEPENDING ON
PLAYING CONDITIONS.
HYPER5™ REGULATOR DISASSEMBLY INSTRUCTIONS
The Hyper5™ assembly is housed in a self-contained cartridge. A fouled Hyper5™
cartridge can be quickly removed for service. In most cases the only seal that needs to be
serviced is the regulator seat, located in the seat retainer. The rubber sleeve on the outside
of the Hyper5™ does not need to be removed to disassemble the Hyper5™.
• Using a 1/4” Allen wrench, Unscrew and remove the Hyper5™ assembly cartridge
from the bottom of the Hyper5™ fore grip housing.
• The Hyper5™ piston and shim stack may or may not come out with the cartridge.
If the piston and shim stack remain in the Housing, use a pair of needle nose pliers
to gently pull the piston out.
CHANGING THE HYPER5™ REG SEAT
• Unscrew the 3 retaining screws holding the service nut using a .050” Allen Wrench.
• Remove the Hyper5™ service nut from the Hyper5™ Cartridge.
• Unscrew and remove the brass Hyper5™ seat retainer using a 3⁄16” Allen wrench.
• Use a dental pick or sharp object to remove the old seat from the retainer and replace it
with a new one. Use a flat object to press it into place.
• Lube the 010 O-ring, and screw the seat retainer assembly back into the cartridge.
HYPER5™ CARTRIDGE ASSEMBLY AND INSTALLATION
• Insert the service nut into the cartridge and secure it with the three retaining screws.
• Make sure the shim stack is properly assembled onto the piston (see image on page 17).
• Apply Grease to the 015 Red Piston O-rings and bottom 3/8” of the piston shaft.
• Insert piston shaft into the top of the Hyper5™ cartridge.
• Be sure to grease the two 015 Red O-rings on the outside of the Hyper5™ cartridge.
Take care when inserting the cartridge, not to cut or pinch outer o-rings on the
cross holes and threads in the Hyper5™ fore grip housing.
• Install the assembled cartridge into the Hyper5™ fore grip housing using a 1/4” Allen.
• THE HYPER5™ CAN HOLD A SMALL RESIDUAL CHARGE
OF GAS, TYPICALLY 1 SHOT.
ALWAYS DISCHARGE THE MARKER IN A SAFE DIRECTION
TO RELIEVE THIS RESIDUAL GAS PRESSURE.
• IMPROPER STACKING OF SHIMS WILL CAUSE FAILURE OF
THE REGULATOR AND POSSIBLE DAMAGE TO THE M2.
• EXCESSIVE DIRT AND DEBRIS CAN AFFECT THE
HYPER5™’S PERFORMANCE AND INCREASE THE NEED
FOR SERVICE.