User's Manual Part 2

18
WWW.DYEPAINTBALL.COM
BASIC VELOCITY ADJUSTMENT
ADJUSTMENTS
The Hyper5 regulator controls your velocity.
It is pre-set at approximately 140 psi. This will enable your gun to shoot about 285 FPS. The M2’s velocity
will be affected by paint size, weather conditions, altitude and other factors.
To adjust your velocity use a 3/16” Allen wrench and insert it into the bottom of the fore grip where the
Hyper5 reg is located.
To lower the velocity turn the Allen wrench clockwise (inward),
this will decrease the pressure.
To raise the velocity turn the Allen wrench counter clockwise (outward)
this will increase the pressure.
Each 1/2 turn will change the Hyper5 reg output Pressure by approximately 15PSI.
The M2 is equipped with an internal pressure sensor for the Hyper5. You are able to view your Hyper5
reg pressure at any time on the OLED screen. The Pressure readings can be viewed by entering into the
Data Settings Menu and scrolling to the Pressure Gauge Screen (see page 7), or while in the Playing
Screen you can press the joystick left and the Systems Check screen will appear for 10 seconds and
display your M2’s PSI reading, along with other information about the M2’s operating system (see page 4).
HYPER5
™
GAS THRU REGULATOR
• THE HYPER5™ CAN HOLD A SMALL RESIDUAL CHARGE OF GAS, TYPICALLY 1 SHOT.
ALWAYS DISCHARGE THE MARKER IN A SAFE DIRECTION TO RELIEVE THIS RESIDUAL
GAS PRESSURE.
• IMPROPER STACKING OF SHIMS WILL CAUSE FAILURE OF THE REGULATOR AND
POSSIBLE DAMAGE TO THE M2.
• EXCESSIVE DIRT AND DEBRIS CAN AFFECT THE HYPER5™’S PERFORMANCE AND
INCREASE THE NEED FOR SERVICE.
2
3
4
5
6
7 7
7
8
9
11
10
12
13
14
1
1 007 UR 90
2 014 BN 70
3 Body
4 Attachment Screw
5 Piston
6 Shim Stack (12 Pieces)
)()()()()()( Correct Orientation
7 015 BN 70 (4 pieces)
8 Cartridge
9 008 UR 90
10 4-40x1/8” Retaining Screws
(3 pieces)
11 Seat (mounted in the seat retainer)
12 010 BN 70
13 Seat Retainer, also functions as
an adjustment screw
14 Service Nut
FUSE™ BOLT O-RING LIST (COLOR CODED)