User's Manual Part 2

23
WWW.DYEPAINTBALL.COM
LOCK DOWN MICRO FEED NECK
The Lock Down Micro Feedneck is
adjustable to fit any standard loader. To
adjust the cam locking system, lift the
cam lever away from the feed collar, and
rotate the lever clockwise to tighten or
counterclockwise to loosen the grip on
the loader. Once the cam lever is facing in
the forward direction, press the cam lever
down against the feed collar to secure
the loader in the feedneck. To loosen the
locking system and remove the loader, lift
the cam lever away from the feed collar.
Take care not to over-tighten the cam
locking system. The lever should not be
overly difficult to lower into the locked position.
REMOVING ULTRALITE FRAME FROM THE M2
If there is ever need to remove the Ultralite frame from the M2 make sure to follow
these steps.
Remove the UL Sticky grips from the frame to expose the rear mounting screw.
Using a 3 ⁄ 32” Allen wrench, remove back frame screw.
Unscrew front frame screw until the frame can drop free of the M2 body.
The M2 unitizes a positive force contact pad to link the body and frame electrical
components together. There are no wires to disconnect when removing the frame from
the Body.
NOTE: BE SURE THAT THE FRAME AND TRIGGER ASSEMBLY ARE KEPT CLEAN.
IF THERE IS EXCESS DIRT OR PAINT BUILD UP AROUND THE TRIGGER, THE
TRIGGER WILL NO LONGER MOVE FREELY. IN ADDITION, PAINT AND DIRT CAN
CAUSE THE MICRO SWITCH TO NOT FUNCTION PROPERLY OR FAIL.
ULTRALITE FRAME & LOCK DOWN MICRO FEED NECK