Installation Guide

Diagram 2

Step 3: A. Insert the faucet handle shank (1) with mounting nut (2) through the deck

handle mounting hole from underneath the sink. Apply gasket (3) onto the top

of the shank and screw on the faucet handle base (4), then reattach handle (5)

onto valve connector (6). Screw handle base (4) until it connects with faucet

handle (5) on the shank.

B. Do not over tighten the handle base to the faucet handle, as it will

prevent the handle from turning smoothly. Test the handle to ensure it can

easily turn on and o. Ensure the handle shank is facing the right direction

(as indicated in the Diagram 2B) and that the handle can rotate 90 degrees.

Note: The handles should rotate 90 degrees toward the front, not the back.

Finally, tighten the mounting nut (2) until it can no longer tighten and replace

the screw (7) onto the faucet handle. Repeat steps for second handle. The

completed faucet handles assembly is represented in Diagram 2B.