Installation Sheet

- 2 -
1
M965648
2
3
INSTALL SUPPLY SHANKS TO LAVATORY
ATTACH FAUCET BODY
• From behind the sink, insert SUPPLY SHANKS (3) with washers into the faucet holes.
• Install ESCUTCHEON (4) and ADAPTER NUT (5) onto each SUPPLY SHANK (3).
Hand tighten. These parts must be installed loosely and should
be able to move around within the two sink holes. Keep Inlet
Holes on SUPPLY SHANKS (3) facing down.
• Insert faucet inlets into previously installed ADAPTER NUTS and SUPPLY SHANKS.
• Gradually hand tighten MOUNTING NUTS (6) evenly. If they become too dif cult
to turn and are binding, please check the following:
— The mounting parts are not loose enough.
— One side has been over tightened too much
and the body is uneven.
• Install METAL WASHER (1) and RUBBER WASHER (2)
onto each SUPPLY SHANK (3).
INSTALL MOUNTING WASHERS
1
2
1
2
3
3
4
4
5
3
INLET HOLES
FACING DOWN
5
3
6
DXV SINK INSTALLATION