Installation Sheet

- 2 -
6
4
3
5
1
2
7
GROOVE
(EXTENSION
BASE)
HOLES
PINS
MOUNTING
SURFACE
D35109100
D35109150
M965713 Rev. 1.1 (3/17)
1
2
• Seat SEAL (1) into under side of ESCUTCHEON (2).
• Install FAUCET SUPPLIES (3) through ESCUTCHEON (2). Align holes
in ESCUTCHEON (2) with pins in faucet. Install ESCUTCHEON (2).
• Feed FAUCET SUPPLIES (3), MOUNTING STUD (4) and LIFT ROD (5)
through the mounting hole of lavatory or mounting surface.
• From below, push GASKET and RETAINING WASHER (6) onto
MOUNTING STUD (4). Secure Faucet with MOUNTING NUT (7).
• Adjust Faucet so that it is centered. Tighten MOUNTING
NUT (7) to complete faucet mounting.
Figure 2a
• Apply a bead of PUTTY (1) to underside of FLANGE (2).
• Drop FLANGE (2) into LAVATORY DRAIN (3). From below
assemble RUBBER GASKET (4), PLASTIC WASHER (5) and
LOCK NUT (6) onto DRAIN FLANGE (2). Do not tighten fully.
Figure 2b
• Inspect inside DRAIN BODY (7) that SEAL (8) is installed.
Thread DRAIN BODY (7) tight against FLANGE (2) to make
a water tight seal. The PIVOT ROD OPENING (9) in DRAIN
BODY (7) should face the rear of the lavatory. Tighten LOCK
NUT (6) on FLANGE (2) to make a water tight connection
with channel locks. Do not over tighten.
• Apply sealant or Teon tape to threads of TAILPIECE (10)
and thread into DRAIN BODY (7) making a water tight seal.
Figure 2c
• Assemble PIVOT ROD (11), WASHER (20) and PIVOT
NUT (12) as shown. Install CONCAVE WASHER (19) into
PIVOT ROD OPENING (9) if not preinstalled. Hand tighten
PIVOT NUT (12). Drop STOPPER (13) into drain. (To vandal
proof drain rotate STOPPER (13) so PIVOT ROD (11) goes
through EYE (14) of STOPPER (13). Make connection
to “P” TRAP.
• Assemble POP-UP SWIVEL (15) to PIVOT ROD (11) but
do not tighten. Drop POP-UP ROD (16) through other hole
in POP-UP SWIVEL (15) and tighten SET SCREW (17).
• Adjust STOPPER (13) height by repositioning POP-UP
ROD (16) in SWIVEL (15) and tightening SET SCREW (18).
INSTALL FAUCET (D3510910C & D3510915C)
INSTALL POP-UP DRAIN
CAUTION
Turn off hot and cold water
supplies before beginning.
APPLY SEALANT
OR TEFLON TAPE
FIG. 2a
FIG. 2b
FIG. 2c
4
3
2
1-
5
6
7
8
6
9
10
9
7
6
12
19
16
1517
18
2
10
14
13
11
20
PUTTY