Installation Sheet

- 5 -
HOT
2
2
COLD
“P” TRAP
WASTE
OUTLET
4
6
1
5
3
1
M965710 Rev. 1.0 (5/17)
12
13
14
• With HANDLE (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
• Remove AERATOR (3). Loosen AERATOR HOUSING (4)
and remove AERATOR (3).
• Operate HANDLES (1) to ush water lines thoroughly.
• Replace AERATOR (3) and tighten AERATOR HOUSING (4).
• Operate POP-UP KNOB (5) and ll lavatory with water.
Check that DRAIN STOPPER (6) makes a good seal and
retains water in Sink. If DRAIN STOPPER (6) does not
seal properly, please refer to Troubleshooting section in
these instructions.
• Push POP-UP KNOB (5) down and check all drain
connections and “P” trap for leaks. Tighten if necessary.
TO CLEAN AERATOR
• AERATOR (3) may accumulate dirt causing distorted
and reduced water ow. Remove AERATOR (3) and
rinse clean.
• Replace AERATOR (3) and operate handles several
times from OFF to ON position. Do not force,
handles turn only 90˚.
CONNECT DRAIN
TEST INSTALLED FITTING
CHECK DRAIN CONNECTIONS
WASTE
OUTLET
1-1/4" (32mm) O.D.
TAILPIECE
• Connect 1-1/4" (32mm) O.D. tailpiece on POP-UP DRAIN to waste outlet.