Installation Sheet

- 4 -

M965710 Rev. 1.0 (5/17)

ATTACH CABLE CONNECTOR

CHECK OPERATION OF POP-UP

MAKE WATER SUPPLY AND WASTE CONNECTIONS

• Thread CABLE CONNECTOR (1) clockwise

onto DRAIN BODY CONNECTION (2) and

hand tighten. Fig. A.

Your new POP-UP DRAIN installation is

now complete. Fig. B.

Note: Tailpeice on pop-up drain is

1-1/4" O.D. (32mm) Fig. B.

• Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes.

Note: If STOPPER (2) does not open and close properly then refer to the

“troubleshooting section” of these instructions.

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT INCLUDED

AND MUST BE PURCHASED SEPARATELY.

• Connect water supply to VALVE BODIES (1,1A) with 1/2" IPS FLEXIBLE

SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3). Use

adjustable wrench to tighten connections. Do not over tighten.

Be careful not to kink copper supply when bending. Use tubing

cutter to cut to proper length.

• Connect HOT water supply to inlet of left SHANK and COLD

water supply to right SHANK using sealant, appropriate

connectors, and COUPLING NUTS.

Fig. A.

1-1/4" O.D.

(32mm)

Fig. A.

Fig. B.

HOT

COLD

FERRULE

COMPRESSION

NUT

COUPLING

NUT

FLEXIBLE

SUPPLIES

3/8" (6mm) O.D.

BULL-NOSE

RISERS

1/2" (13mm) PIPE

THREAD

3/8" (6mm) COMPRESSION

CONNECTION