Installation Sheet

- 3 -
M965709 Rev. 1.0 (5/17)
4
INSTALL HANDLES
5
TEST INSTALLED FAUCET
• With HANDLE (1) in OFF position, turn on WATER SUPPLIES and check all connections for leaks.
• Remove AERATOR (2). First loosen aerator set screw with HEX WRENCH (3) supplied.
Pull out AERATOR (2) with AERATOR KEY (4).
• Operate HANDLES (1) to ush water lines thoroughly.
• Replace AERATOR (2) and tighten set screw.
• Slide BARREL SLEEVE WASHER (1) onto VALVE STEM (2) until WASHER (1) is on the smooth section of the VALVE STEM (2).
• Thread BARREL SLEEVE (3) onto VALVE BODY (4) and tighten.
• Make sure ESCUTCHEON O-RING (5) is in place. Slide ESCUTCHEON (6) onto BARREL SLEEVE (3) ush against nished wall.
• Align HANDLE as shown or as desired and install HANDLE ASSEMBLY (7, 7a) onto VALVE STEM (2).
• Thread HANDLE BASE (8) onto BARREL SLEEVE (3) until tight.
• Turn on the water supply. Check that the tting works correctly and does not leak.
2
4
5
6
1
7a
7
3
SMOOTH SECTION
8
8
OFF
ON
OFF
ON
1
2