Installation Sheet

- 2 -

M965708 Rev. 1.0 (5/17)

• Seat O-RING SEAL (1) into under side of FAUCET BASE (2).

• Feed FAUCET SUPPLIES (3), MOUNTING STUD (4) and DRAIN CABLE ASSEMBLY (8) through the mounting hole of lavatory

or mounting surface. Fig. A.

• From below, push GASKET (7) and RETAINING WASHER (5) onto MOUNTING STUD (4). Secure Faucet with MOUNTING

NUT (6), pulling faucet to front of sink, so SUPPLIES (3) rests against mounting hole. Before nal tightening, make sure collar

on MOUNTING NUT (6) is seated into RETAINING WASHER (5). Fig. B.

• Adjust Faucet so that it is centered. Tighten MOUNTING NUT (6) to complete faucet mounting.

INSTALL FAUCET

CAUTION

Turn off hot and cold water

supplies before beginning.

GROOVE

(FAUCET BASE)

MOUNTING SURFACE

Fig. A.

COLLAR ON

MOUNTING NUT

Fig. B.