Installation Sheet

- 3 -
M965708 Rev. 1.0 (5/17)
2
3
4
6
5
POP-UP DRAIN
REMOVE MOUNTING WASHERS
AND LOCKNUT
ATTACH DRAIN FROM
BELOW FIXTURE
FLANGE GASKET AND POP-UP KNOB
TIGHTEN LOCKNUT
• Remove CLEAR PLASTIC COVER (1). Fig. A.
• Remove FOAM SPACER (2) from
under DRAIN POP-UP (3). Fig. A.
• Tighten TAILPIECE (4) on DRAIN BODY
before installing DRAIN BODY. Fig. B.
• Thread LOCKNUT (1) counter-clockwise
and remove from drain body. Remove
PLASTIC WASHER (2) and pull off
RUBBER CONE WASHER (3) Fig. A.
• Drop DRAIN BODY (4) through sink drain
hole. Make sure WHITE FOAM GASKET (5)
is under ange of DRAIN BODY (4). Fig. B.
Note: No plumber’s putty or caulk is required.
• The CABLE ATTACHMENT POINT (6) must
face towards the rear of the SINK. Fig. B.
• From under side of SINK install
RUBBER CONE WASHER (3),
PLASTIC WASHER (2) and
LOCKNUT (1) onto DRAINBODY (4).
Note: The CABLE ATTACHMENT
POINT (5) must face towards
the rear of the SINK.
• Check DRAIN FLANGE in SINK to ensure that
WHITE FOAM GASKET (3) is fully compressed
and not visible. Fig. A.
• POP-UP KNOB (1) must be fully down. Fig. B.
2
3
1
DRAIN
BODY
4
Fig. A. Fig. B.
Fig. A. Fig. B.
REAR OF
SINK
4
5
6
SINK
DRAIN
HOLE
1
3
2
Fig. A. Fig. B.
WHITE FOAM
GASKET
NOT VISIBLE
DRAIN
FLANGE
DOWN
UP
1
1
5
3
2
4
1
• Tighten LOCKNUT (1) rmly with
Adjustable Wrench or Channel Locks.