Installation Sheet

- 5 -
M965520 Rev. 2.3 (7/18)
3
6
5
7
9
9
1
4
2
8
• Insert SEAL WASHER (1) and connect BRACKET (2) to
BRACKET NIPPLE (3) on top of FAUCET. Align and tighten rmly.
• Insert SEAL WASHER (4) and connect smaller end of HOSE (5)
to outlet Nipple on side of BRACKET (2).
• Insert SEAL WASHER (6) to conical end of HOSE (5) and
attach HAND SPRAY.
• Turn VALVES to “off” position.
• With handles in “off” position, turn on water
supplies and check all connections for leaks.
• Lift HAND SHOWER (7) from the holder and
remove it from HOSE (5). Direct spray into tub.
Turn DIVERTER KNOB (8) and check HOSE (5)
connections for leaks.
• Operate HANDLES (9) on to off, hot and cold
to ush water lines thoroughly.
• Turn DIVERTER KNOB (8) in and thread HAND
SHOWER (7) onto HOSE (5).
• Turn VALVE to OFF position.
• Push CROSS HANDLE (1) or LEVER
HANDLE (1a) onto VALVE STEM (2).
Check alignment if not satisfactory align.
• Thread HANDLE BASE (3) tight onto VALVE (4).
6
6a
5
INSTALL FITTING BRACKET
TEST INSTALLED FAUCET
INSTALL HANDLES IF NOT INSTALLED
3
1
1a
2
4
CAUTION
The flow rate of this Tub Filler exceeds 20 gallons/minute
at higher water pressure. Do not fill bathtub unattended.