Installation Sheet

- 4 -

M965705 Rev. 1.1 (2/17)

ATTACH CABLE CONNECTOR

CHECK OPERATION OF POP-UP

MAKE WATER SUPPLY AND WASTE CONNECTIONS

• Thread CABLE CONNECTOR (1) clockwise

onto DRAIN BODY CONNECTION (2) and

hand tighten. Fig. A.

• Your new POP-UP DRAIN installation is

now complete. Fig. B.

Note: Tailpeice on pop-up drain is

1-1/4" (32 mm) O.D. Fig. B.

• Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes.

Note: If STOPPER (2) does not open and close properly then refer

to the “troubleshooting section” of these instructions.

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT INCLUDED

AND MUST BE PURCHASED SEPARATELY.

• Connect water supply to VALVE BODIES (1,1A) with

1/2" (12.7 mm) IPS FLEXIBLE SUPPLIES (2) or 3/8" (9.5 mm)

O.D. BULL-NOSE RISERS (3). Use adjustable wrench to

tighten connections. Do not over tighten. Be careful not

to kink copper supply when bending. Use tubing cutter

to cut to proper length.

• Connect HOT water supply to inlet of left SHANK and

COLD water supply to right SHANK using sealant,

appropriate connectors,and COUPLING NUTS.

waste outlet.

1-1/4” O.D.

Fig. A. Fig. B.

HOT

COLD

FERRULE

COMPRESSION

NUT

COUPLING

NUT

FLEXIBLE

SUPPLIES

3/8" (9.5 mm)

O.D. BULL-NOSE

RISERS

1/2" (12.7 mm)

PIPE THREAD

3/8 COMPRESSION

CONNECTION