Installation Sheet

- 2 -
M965705 Rev. 1.1 (2/17)
1 2
3
HOSE ASSEMBLY
SPOUT ASSEMBLY TEE ASSEMBLY
CAUTION
Turn off hot and cold water
supplies before beginning.
• Thread TEE BODY (1) COUPLING NUT (2)
to SPOUT SHANK (3).
1213
14
11
COLD
1-1/4" (32mm) MAX.
6
8
HOT
9
10
7
5
2
"O" RING
TUB DECK OR
MOUNTING SURFACE
1
1A
3
4
5
7
2
6
SLOT
3
8
4
GROOVE
1
1
3
2
• Insert SPOUT (1) and CABLE
CONNECTOR (2) through center hole,
making sure SEAL WASHER (3) is
properly seated in SPOUT BASE (4)
groove.
• Assemble RUBBER
WASHER (5), BRASS
WASHER (6) and LOCKNUT (7)
onto SPOUT SHANK (8) from under
side of sink. Make sure SPOUT (1)
is centered in the mounting hole
and the slot in the BRASS
WASHER (6) faces toward
the rear of the sink.
• Tighten LOCKNUT (7)
rmly.
• HANDLE ASSEMBLIES (1) are installed on VALVE BODIES (2)
and must be removed to install VALVE BODIES (2) from under
lavatory or mounting surface.
• To remove HANDLE ASSEMBLY (1), unthread HANDLE BASE (3)
with LEVER (4) from VALVE BODY (2). Pull HANDLE ASSEMBLY (1)
off VALVE STEM (5).
• Unthread and remove MOUNTING RING (6) and SPACER (7).
• Thread LOCKNUT (8) to bottom of VALVE BODY (2). Make sure
FIBER WASHER (9) and RUBBER WASHER (10) are installed.
Insert VALVE BODY (2) through mounting hole from underside
of lavatory or mounting surface.
Note: VALVE BODY marked with Red Dot is installed in the left mtg.hole,
VALVE BODY marked with Blue Dot in the right when facing front
of fitting. Maximum mounting surface thickness is 1-1/4" (32 mm).
• From top install SPACER (7) onto VALVE BODY (2). Thread MOUNTING
RING (6) on VALVE BODY (2) until seated tightly against SPACER (7).
Set VALVE BODIES (2) so that their outlets are facing toward SPOUT TEE (11)
and thentighten LOCKNUT (8) using 35 mm or adjustable wrench.
• Tighten COUPLING NUT (12) on SUPPLY HOSE (14) to OUTLET (13) making water tight connection.
Important: Loop SUPPLY HOSES (14) as shown so they do not kink.
INSTALL HANDLES (LEVER and CROSS)
• Turn VALVE BODIES (2) to off position. Align HANDLES as shown or as desired and install HANDLE ASSEMBLY (1, 1A)
onto VALVE STEM (5). Thread HANDLE BASE (3) onto VALVE BODY (2) until seated tightly against mounting surface.