Installation Sheet

- 2 -

M965704 Rev. 1.1 (2/17)

• Install O-RING (1) into O-ring groove of FAUCET BASE (2).

• Feed FAUCET SUPPLY TUBES (5) and SHANK (3) and DRAIN CABLE ASSEMBLY (9) through

mounting hole of lavatory or mounting surface.

• From below, Install RUBBER SEAL with RETAINING WASHER (4) and LOCKNUT (6) onto faucet

SHANK (3). Before nal tightening, faucet should be seated ush on mounting surface. Adjust

faucet so that it is centered and covers mounting hole. Tighten LOCKNUT (6) using a 15mm or

adjustable wrench. Do not over tighten.

• Installation is the same for VESSEL FAUCET (8).

INSTALL FAUCET (LAVATORY AND VESSEL FAUCETS)

CAUTION

Turn off hot and cold water

supplies before beginning.

MOUNTING

SURFACE