Installation Sheet

- 3 -
M965703 1.0 (5/17)
4
5
6
WATER SUPPLY CONNECTIONS
MAKE WATER SUPPLY CONNECTIONS
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS
MUST BE PURCHASED SEPARATELY.
• Connect water supply to VALVE BODIES (1) with 1/2" (13 mm) IPS
FLEXIBLE SUPPLIES (3) or 3/8" (10 mm) O.D. BULL-NOSE RISERS (4).
Use wrench to tighten connections.
• Do not over tighten. Be careful not to kink copper supply when
bending. Use tubing cutter to cut to proper length.
• Remove AERATOR (3) from faucet.
• With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2)
and check all connections for leaks.
Operate both HANDLES to ush water lines thoroughly.
• Operate Lift Rod (5) and ll lavatory with water. Check that DRAIN
STOPPER (4) makes a good seal and retains water in lavatory.
Adjust stopper height by repositioning Lift Rod (5) and
tightening SET SCREW (6).
• Release DRAIN STOPPER (4) and check all drain connections and
“P” trap for leaks. Tighten if necessary.
• Replace AERATOR (3).
INSTALL POP-UP DRAIN
FIG. 4a
• A FOAM SEAL (1) is installed on underside of FLANGE (2).
(Plumbers Putty may be used in place of FOAM SEAL (1) if desired.)
• Drop FLANGE (2) into LAVATORY DRAIN (3). From below assemble
RUBBER GASKET (4), PLASTIC WASHER (5) and LOCK NUT (6)
onto DRAIN FLANGE (2). Do not tighten fully.
FIG. 4b
• Inspect inside DRAIN BODY (7) that SEAL (8) is installed. Thread
DRAIN BODY (7) tight against FLANGE (2) to make a water tight seal.
• The PIVOT ROD OPENING (9) in DRAIN BODY (7) should face the rear
of the lavatory. Tighten LOCK NUT (6) on FLANGE (2) to make a water
tight connection with channel locks. Do not over tighten.
• Apply sealant or Teon tape to threads of TAILPIECE (10) and
thread into DRAIN BODY (7) making a water tight seal.
FIG. 4c
• Assemble PIVOT ROD (11), WASHER (20) and PIVOT NUT (12) as shown.
Install CONCAVE WASHER (19) into PIVOT ROD OPENING (9) if not
reinstalled. Hand tighten PIVOT NUT (12). Drop STOPPER (13) into drain.
(To vandal proof drain rotate STOPPER (13) so PIVOT ROD (11) goes
through EYE (14) of STOPPER (13). Make connection to “P” TRAP.
• Assemble POP-UP SWIVEL (15) to PIVOT ROD (11) but do not tighten. Drop
POP-UP ROD (16) through other hole in POP-UP SWIVEL (15) and tighten SET SCREW (17).
• Adjust STOPPER (13) height by repositioning POP-UP ROD (16) in SWIVEL (15) and tightening SET SCREW (18).
APPLY SEALANT
OR TEFLON TAPE
FIG. 4c
FIG. 4a
FIG. 4b
1
4
3
2
5
6
7
8
6
9
2
10
9
7
6
12
19
16
1517
18
2
10
14
13
11
20
3
1
4
FERRULE
COUPLING NUT
2
2
1
4
5
6
3