Installation Sheet
- 5 -
M965702 Rev. 1.1 (5/17)
12
13
14
• Connect 1-1/4" O.D. tailpiece on POP-UP DRAIN to waste outlet.
• With HANDLE (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
• Remove AERATOR (3). First loosen aerator set screw with
HEX WRENCH (4) supplied. Pull out AERATOR (3) with
AERATOR KEY (5).
• Operate HANDLE (1) to ush water lines thoroughly.
• Replace AERATOR (3) and tighten set screw.
• Operate POP-UP KNOB (6) and ll lavatory with water.
Check that DRAIN STOPPER (7) makes a good seal and
retains water in Sink. If DRAIN STOPPER (7) does not
seal properly, please refer to Troubleshooting section in
these instructions.
• Push POP-UP KNOB (6) down and check all drain
connections and “P” trap for leaks. Tighten if necessary.
TO CLEAN AERATOR
• AERATOR (3) may accumulate dirt causing distorted
and reduced water ow. Remove AERATOR (3) and
rinse clean.
• Replace AERATOR (3) and operate handles several
times from OFF to ON position. Do not force,
handles turn only 90˚.
CONNECT DRAIN
TEST INSTALLED FITTING
CHECK DRAIN CONNECTIONS
HOT
2
2
COLD
“P” TRAP
WASTE
OUTLET
3
5
4
1
7
1
6
WASTE
OUTLET
1-1/4” O.D.
TAILPIECE