Installation Sheet

- 2 -
M965702 Rev. 1.1 (5/17)
2
3
1
TEE ASSEMBLY
INSTALL VALVE BODIES
• Insert SPOUT (1) and CABLE
CONNECTOR (2) through center
hole, making sure SEAL WASHER (3)
is properly seated in SPOUT
BASE (4) groove.
• Assemble RUBBER WASHER (5),
BRASS WASHER (6) and
LOCKNUT (7) onto SPOUT
SHANK (8) from under side
of sink. Make sure SPOUT (1)
is centered in the mounting
hole and the slot in the BRASS
WASHER (6) faces toward
the front of the sink.
• Tighten LOCKNUT (7) rmly.
SPOUT ASSEMBLY
CAUTION
Turn off hot and cold water
supplies before beginning.
• Thread TEE BODY (1) COUPLING NUT (2) to
SPOUT SHANK (3). Tighten with wrenches.
• Unpack valve assembly and remove HANDLE (10) by unthreading
SET SCREW (12). Unthread ROSETTE (9) and FLANGE (8)
removing them from VALVE BODY (2).
• Thread LOCKNUT (1) to bottom of VALVE BODY (2). Make sure
SPACER (3), BRASS WASHER (4) and RUBBER WASHER (5)
are installed.
• Insert VALVE BODY (2) through mounting hole from underside
of lavatory or mounting surface.
Note: VALVE BODY marked Hot is installed in the left Mtg. hole,
VALVE BODY marked Cold in the right when facing front of
fitting. Maximum mounting surface thickness is 1-3/4".
• Install STOP RING (6) onto VALVE BODY (2) if not in place. Install
O-RING (7) into groove in FLANGE (8).
• U Thread FLANGE (8) ush against STOP RING (6). Thread
ROSETTE (9) onto VALVE BODY (2) until tight against it’s internal stop.
• Align VALVE BODY (2) and from below tighten LOCKNUT (1)
to secure VALVE BODY (2).
INSTALL HANDELS
• Turn VALVES to off position. Align HANDLES (10) as shown or as desired
and install onto HANDLE ADAPTER (11). Tighten SET SCREW (12) with
HEX WRENCH (13) supplied. Push PLUG BUTTON (14) into place.
HOSE CONNECTIONS
• Tighten COUPLING NUT (12) on SUPPLY HOSE (17) to OUTLET (15) making water tight connection.
Important: Loop SUPPLY HOSES (17) as shown so they do not kink.
5
7
2
6
SLOT
3
8
4
1
1
3
2
1-3/8'' (35mm) MAX.
STOP RING
GROOVE
1
2
HOT
15
5
12
COLD
9
17
16
3
4
8
12
14
13
6
11
9
10
7