Installation Sheet

- 5 -
M965700 Rev. 1.0 (3/17)
10
• With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.
• Remove AERATOR (3). First loosen aerator set screw with HEX WRENCH (4) supplied. Pull out AERATOR (3) with
AERATOR KEY (5).
• Operate HANDLE (1) to ush water lines thoroughly.
• Replace AERATOR (3) and tighten set screw.
CHECK DRAIN CONNECTIONS
• Operate POP-UP KNOB (6) and ll lavatory with water. Check that DRAIN STOPPER (7) makes a good seal and retains
water in Sink. If DRAIN STOPPER (7) does not seal properly, please refer to Troubleshooting section in these instructions.
• Release POP-UP KNOB (6) down and check all drain connections and “P” trap for leaks. Tighten if necessary.
TEST INSTALLED FITTING
6
3
4
1
5
OFF
ON
HOT
COLD
“P” TRAP
WASTE
OUTLET
2
2
7