Installation Sheet

- 4 -

M965700 Rev. 1.0 (3/17)

ATTACH CABLE CONNECTOR

CHECK OPERATION OF POP-UP

MAKE WATER SUPPLY AND WASTE CONNECTIONS

• Thread CABLE CONNECTOR (1) clockwise

onto DRAIN BODY CONNECTION (2) and

hand tighten. Fig. A.

Your new POP-UP DRAIN installation is

now complete. Fig. B.

Note: Tailpeice on pop-up drain is 1-1/4" O.D.

Fig. B.

• Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes.

Note: If STOPPER (2) does not open and close properly then refer to the

“troubleshooting section” of these instructions.

• Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies.

Connection on tting supplies are 3/8" compression. Connect

left SUPPLY (1) to Hot (Marked with a Red Band) and right supply

to COLD (2) wall supply.

• Faucet supplies are 20" long from faucet base.

Note: If additional supply length is required, installer must

purchase additional parts separately.

Important: If SUPPLY HOSES (1, 2) are to long, loop as

illustrated to avoid kinking.

• Connect 1-1/4" O.D. tailpiece on POP-UP DRAIN to

waste outlet.

1-1/4” O.D.

Fig. A. Fig. B.

APPROX. 20"

COLD

HOT

3/8" COMPRESSION

RED

BAND

BLUE

BAND