Installation Sheet

- 3 -
M965700 Rev. 1.0 (3/17)
2
3
4
6
5
POP-UP DRAIN
REMOVE FLANGE
INSTALL DRAIN FROM
BELOW FIXTURE
FLANGE GASKET AND POP-UP KNOB
TIGHTEN LOCKNUT
• Remove CLEAR PLASTIC COVER (1).
• Remove CARDBOARD SPACER (2) from
under DRAIN POP-UP (3).
• Tighten TAILPIECE (4) on DRAIN BODY
before installing DRAIN BODY. Fig. B.
• Thread FLANGE (1) counter-clockwise and
remove FLANGE (1) and FOAM GASKET (2)
from drain body. Fig. A.
• Thread LOCKNUT (3) clock-wise to bottom
of drain body. Push GASKET (4) down
against LOCKNUT (3). Fig. B.
• From under side of SINK
install DRAIN BODY (1) up
through drain outlet.
Note: No plumber’s putty
or caulk is required.
The CABLE ATTACHMENT
POINT (2) must face
towards the rear of
the SINK.
• Install FOAM GASKET (3) and
FLANGE (4) onto drain body
from above SINK and tighten
FLANGE (4) rmly.
• Check DRAIN FLANGE in SINK to ensure that
WHITE FOAM GASKET (3) is fully compressed
and not visible. Fig. A.
• POP-UP KNOB (1) must be fully down.
Fig. B.
• Tighten LOCKNUT (1) rmly with
Adjustable Wrench or Channel Locks.
2
3
1
DRAIN
BODY
4
Fig. A. Fig. B.
3
4
2
1
Fig. A.
Fig. B.
WHITE FOAM
GASKET
NOT VISIBLE
DRAIN
FLANGE
1
DOWN
Fig. A.Fig. A.
Fig. B.
REAR OF SINK
DRAIN
OUTLET
2
1
3
4
1