Specification Sheet

AT200
®
LS
SPALET
®
INTEGRATED ELECTRONIC
BIDET TOILET
©2019 AS America Inc.
41-5/16" min.
(1050 mm)
27-9/16"
min.
(700 mm)
14-3/4"
(375 mm)
1*
2-3/4"
min.
(70 mm)
2*
2" min.
(50 mm)
9/16" min.(15 mm)
1*
2-3/4"
min.
(70 mm)
14-3/4"
(375 mm)
9-1/16"
(230 mm)
Finish
Wall
3-1/4" (82 mm)
7-1/16" (179 mm)
19-5/16"
(491mm)
15-3/4"
(400 mm)
17"
(432 mm)
5-15/16"
(150 mm)
25-13/16"
(655 mm)
3-9/16"-3-15/16" (90-100 mm)
Drainage Pipe
Finish
Wall
7-1/2" (190 mm)
12" (305 mm)
26-9/16"
(674 mm)
NOTES:
This bidet toilet is designed to rough-in at a minimum dimension of 12" (305 mm) from finished wall to C/L of outlet.
Includes flex supply with integral shutoff valve, seat and bolt caps.
Dimensions shown for location of supply is suggested.
Location of the stop valve(water supply) can be adjusted in between the range listed below:
- Stop Valve (water supply) on the wall.
Width: 9-1/16” (230 mm) to 19-11/16” (500 mm) on both left or right from the center of closet flange
Height: 1-31/32” (50 mm) to 23-5/8” (600 mm) from the floor
- Stop valve (water supply) on the floor.
Width: 9-27/32” (250 mm) to 19-11/16” (500 mm) on both left or right from the center of closet flange
Length: 1-31/32” (50 mm) to 5-29/32” (150 mm) from the wall
IMPORTANT:
Dimensions of fixtures are nominal and may vary within the range of tolerance established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.
www.dxv.com4/19
REMOTE CONTROL
Water Spot Dimensions: 8" x 6-1/16" (204 x 154.5 mm)