Specification Sheet

www.dxv.com©2017 AS America Inc. Revised 2/17
FITZGERALD
®
24" PEDESTAL
LAVATORY
1/2" D. (13 mm)
HOLES FOR
ANCHOR BOLTS
SUPPLIES AS
REQUIRED
1-1/4" O.D.
TAILPIECE
1-1/4" O.D.
WASTE
18"
(457 mm)
24"
(609 mm)
3"
(75 mm)
7-7/8"
(200 mm)
4"
(100 mm)
36"
(915 mm)
8"
(203 mm)
8-1/2"
(216 mm)
12-5/8"
(320 mm)
FINISHED
WALL
8"
(203 mm)
22-3/4"
(578 mm)
28-1/2"
(725 mm)
20-3/4"
(527 mm)
FINISHED
FLOOR
1-3/8" D. (35 mm)
FAUCET MOUNTING
HOLES
1-3/4" D.
(45 mm)
9-5/8"
(244 mm)
32-7/8"
(835 mm)
6-1/8"
(155 mm)
17-11/16"
(449 mm)
NOTES:
Dimension shown for location of supplies and “P” trap are suggested. Provide suitable reinforcement for all wall supports.
Pedestal anchoring screws not included
Fittings not included with fixture and must be ordered separately.
Installation Instructions supplied with lavatory and console legs.
IMPORTANT:
Dimensions of fixtures are nominal and may vary within the range of tolerance established by ANSI standards.
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.
FEATURES
• Fine re clay
• Faucet ledge with integral soap recess
• Recessed overow
DIMENSIONS
NOMINAL DIMENSIONS
24" x 18" x 36" (609 x 457 x 915 mm)
Pedestal back open 13-1/2" up from floor
BOWL INSIDE DIMENSIONS
17-11/16" (449 mm) wide
9-5/8" (244 mm) front to back
6-1/8" (155 mm) depth
COLORS/FINISHES
Canvas White (415), Biscuit (071)
SEPARATE COMPONENTS
D20030001.XXX 24" Single-Hole Lavatory
D20030008.XXX 24" Three-Hole Lavatory
D21015000.XXX Pedestal Base Only
COMPLIANCE CERTIFICATIONS
Meets or Exceeds ASME A112.19.2-2008/CSA B45.1-8