Installation Sheet

- 3 -
7302025-100
1
INSTALLATION PROCEDURES
Typical installation includes wall preparation, installation of faucet and pop-up drain, supplies to house water system.
Lavatory Mounting Provisions - Whether the lavatory is used for replacement or new installation, the wall area
behind the lavatory basin mounting holes must be reinforced to provide secure mounting for the new unit.
Preparing Wall for Lavatory Mounting
Optional: For non-masonary installation, crosspieces must be installed to reinforce the lavatory mounting
surface to provide adequate support, install as described below.
1. Remove wallboard/covering from designated area.
2. Toenail 2" x 6" (51mm x 152mm) cross piece between studs (or notch studs to accept a 1" x 6" (25mm x 152mm)
crosspiece, and attach securely). Determine horizontal center line location of support from xture.
3. Replace wallboard/nished wall media.
NOTCH
STUDS OR
TOE-NAIL
DRAIN
PIPE
WATER
SUPPLY
PIPES
LAVATORY
CROSS-PIECE
SUPPORT
INSTALLING CROSS-PIECE:
2
INSTALLING LAVATORY
P.TRAP
COMPRESSION
WASHER
NUT
NUT
COVER
HOUSE DRAIN
PIPE FITTING
LAVATORY
POP-UP DRAIN
TAILPIPE
TYPICAL DRAIN CONNECTIONS TYPICAL WATER SUPPLY LINE CONNECTIONS
TYPICAL APPLICATION
SPREAD LAVATORY SET
FLEXIBLE
SUPPLY LINE
HOT SHUTOFF VALVE
COLD SHUTOFF VALVE
FLEXIBLE
SUPPLY LINE
Bead of Silicon
Geometry shown is for illustration only
and may not match product geometry.
CAUTION: Lavatories are extremely heavy. For personal safety, always use extra person for installation.
1. Using level, draw a vertical line starting at the waste water return hole. Draw a horizontal
line at the required dimension from oor. Check the dimension placing the lavatory and legs
into position. Mark and drill holes through the mounting holes along the horizontal line.
Install lavatory anchor screws leaving 1-7/8" threaded end exposed as illustrated.
2. Apply a bead of silicon to the back of the lavatory. See Diagram.
3. Pre-assemble P-trap drain connections in accordance with manufacturer’s instructions. Check that pop-up drain opens and closes
properly when drain control is operated. Connect supply lines to shutoff valves and loosely install drain connections.
5. Install faucet and drain in accordance with manufacturer’s instructions.
Tighten drain and water supply connections.
Turn on water supply valves and water-test installation.
4. Loosely attach the lavatory to the wall at the anchor locations. Optionally, place the cushioned adhesive-backed or similar product
on the top and bottom of the pedestal to avoid ceramic damage, oor damage and clattering between pedestal and lavatory, and to
level lavatory slab to pedestal.
DO NOT OVER-TIGHTEN MOUNTING HARDWARE
OR LAVATORY MAY BE DAMAGED!
Lavatories Installation Note: Do not tighten nuts at this time, in order to
allow the lavatory to swing up enough to permit the insertion of the legs.
Insert the legs under the lavatory. Ensure that the lavatory sits evenly
against legs. Level lavatory side to side and front to rear, (place a sheet of
tissue under level to protect lavatory), then securely tighten mounting nuts.
See Diagram.
LAVATORY TO WALL ANCHORS
LOCATION 4 PLACES
*
SEE
ROUGH-IN
FINISHED FLOOR
1-7/8"
(48mm)
Anchor Screw
Washer
Lavatory
Nut
FINISHED
WALL