Owner manual

M
echanical Installation
1
. For mounting, select a clean, dry location, free from extreme temperatures.
2
. Cut a 3-7/32˝ (82 mm) diameter hole in the panel for the thermometer.
3
. Prior to inserting the thermometer into the panel, remove the mounting bracket.
4. Insert the thermometer into the panel cutout from the front.
5. Place the U-bracket on the back of the thermometer (make sure the screws are
aligned with the holes in the mounting bracket).
6
. Secure the bracket into place by tightening the nuts until the bracket is tight against
t
he panel.
7. The probe should be mounted so the bulb is fully immersed in the media and where
the media temperature will be evenly distributed.
Electrical Connections
1. Connections for the switch are made by three connections. The quick connect
terminals are labeled N.O., N.C., and COM. N.O. is the normally open terminal,
COM is the common terminal, and N.C. is the normally closed terminal.
2. For NC (normally closed) operation, make switch connections using terminals COM
a
nd N.C.
3
. For NO (normally open) operation, make switch connections using terminals COM
a
nd N.O.
S
et Point Operation
T
he switch set point is fully adjustable across the entire range of the unit. The unit is
e
quipped with internal stops at the minimum and maximum values of a specified
r
ange.
Adjust the set point by rotating the black knob on the front of the dial case to the
desired temperature setting.
M
AINTENANCE/REPAIR
U
pon final installation of the Series RRT3, no routine maintenance is required. The
S
eries RRT3 is not field serviceable and should be returned if repair is needed. Field
repair should not be attempted and may void warranty.
WARRANTY/RETURN
R
efer to “Terms and Conditions of Sales” in our catalog and on our website. Contact
c
ustomer service to receive a Return Goods Authorization number before shipping the
p
roduct back for repair. Be sure to include a brief description of the problem plus any
additional application notes.
©Copyright 2012 Dwyer Instruments, Inc. Printed in U.S.A. 3/12 FR# R5-443930-00
DWYER INSTRUMENTS, INC. Phone: [phone] www.dwyer-inst.com
P.O. BOX 373 • MICHIGAN CITY, INDIANA 46361, U.S.A. Fax: [phone] e-mail: [e-mail]
Do not exceed the specified electrical ratings shown on the unit.
Permanent damage, not covered by the warranty, will result.
C
AUTION
If panel thickness exceeds 13/64˝ (5 mm), the bracket must be
shortened accordingly.
NOTICE
Since temperature effects along the capillary are compensated
f
or, the capillary should not be located close to other
t
emperature sources. Take care in arranging the steel capillary to avoid sharp
b
ends that might kink internal capillary tube.
N
OTICE