Owner's manual

SCAL Scale Low: Select 100 to 9999 counts below SCAH. The total span

between SCAL and S C A H must be within 11998 counts. Maximum setting

range is - 1 9 9 9 to + 9999 counts. Factory Default is - 5 . 7 .

SCAH Scale High: Select 100 to 9999 counts above S C A L . The total span

between SCAL and S C A H must be within 11998 counts. Maximum setting

range is - 1 9 9 9 to + 9999 counts. Factory Default is 23.1.

S P L Set Point Low: Select from the lowest input range value to SPH value. This

will set the minimum SP1L or S P 2L value that can be entered. The value

for SP1L or S P 2 L will stop moving when this value is reached. Factory

Default is -5.7.

SPH Set Point High: Select from the highest input range value to S P Lvalue. This

will set the maximum SP1H or S P2H value that can be entered. The value

for S P 1H or SP2H will stop moving when this value is reached. Factory

Default is 23.1.

S1St Set Point 1 State: Select P i n or P O u t. Factory default is POut.

P in Pump In (Direct Action). As the input increases the output

will increase.

POut Pump Out (Reverse Action). As the input increases the output

will decrease.

5ILP P1 Lamp: Select 0 on or O oFF. Factory default is 0 on.

0 on Lamp ON when Output is ON.

OoFF Lamp OFF when Output is ON.