Instruction manual

Analog Panel Meter Instruction Manual
97
Display Parameter Action/Setting Description
O Hold
Relays output
hold
Assign digital input to hold all relays state
OFF
Off
Disable relay and front panel status LED,
turn relays off, program off time delay
OFF 1
Off
Set relay 1 Off time delay
On
On
Enable fail-safe operation, turn relays on,
program on time delay
On 1
On
Set relay 1 On time delay
O-rang
Overrange
Program mA output for display overrange
Out 1
Output 1
Program output 1 value (e.g. 4.000 mA)
Out 2
Output 2
Program output 2 value (e.g. 20.000 mA)
pass
Password
Enter the Password menu
Pass 1
Password 1
Set or enter Password 1
Pass 2
Password 2
Set or enter Password 2
Pass 3
Password 3
Set or enter Password 3
prog
Program
Enter the Program menu
Prog E
Programmable
exponent
Set meter for programmable exponent and
enter exponent value
rATE
Rate
Assign relay to rate
RELaY
Relay
Enter the Relay menu
reset
Reset
To access the Reset menu
rht
Round horizontal
tank
Set meter for round horizontal tank volume
calculation
Right
Right arrow
Assign digital input to Right arrow button/F1
RLY 1
Relay 1
Relay 1 setup
RLY 2
Relay 2
Relays 2-8 setup
Note: Relays 5-8 are shown, only if
expansion relay module is installed.
Rly d
Disable relay
Assign digital input to disable all relays
Rly E
Enable relay
Assign digital input to enable all relays