Instruction manual

Analog Panel Meter Instruction Manual
96
Display Parameter Action/Setting Description
Inp 2
Input 2
Calibrate input 2 signal or program input 2
value (up to 32 points)
Input
Input
Input selection
LatCH
Latching
Set relay for latching operation (relays
assigned to rate)
LED t
LED test
Test all LEDs
Length
Length
Enter the tank’s length in inches
Linear
Linear
Set meter for linear function and select
number of linearization points
Lit gt
Grand total on
lower display
Assign the digital input to display the grand
total on the lower display
Lit Hi
Max on lower
display
Assign digital input to display max on the
lower display
Lit HL
Max/min lower
display
Assign the digital input to toggle max/min
on the lower display
Lit Lo
Min on lower
display
Assign digital input to display min on the
lower display
Little
Lower display
To assign the lower display parameters
locd
Locked
Enter password to unlock meter
Lt-CLr
Latching-cleared
Set relay for latching operation with manual
reset only after alarm condition has cleared
(relays assigned to rate)
mA
4-20 mA
Set meter for 4-20 mA input
mAn
Manual
To manually control
mAx
Maximum
Program maximum mA output allowed
mbus
Modbus
Select to display Modbus input or to assign
Modbus input as the analog output source
menu
Menu button
Assign digital input to Menu button
min
Minimum
Program minimum mA output allowed
No PtS
Number of points
Set meter for 2 to 32-point linearization
nonrst
Non-resettable
Non-resettable grand total set