Instruction manual

Analog Panel Meter Instruction Manual
29
Display Functions and Messages
The meter displays various functions and messages during setup,
programming, and operation. The following table shows the main menu
functions and messages in the order they appear in the menu.
Display Parameter Action/Setting Description
setup
Setup
Enter Setup menu
Input
Input
Enter Input selection menu
mA
4-20 mA
Set meter for 4-20 mA input
volt
0-10 VDC
Set meter for 10 VDC input
Total
Total
Enable or disable totalizer features
d-SCAL
Dual-scale
Enter d-SCAL menu and select Yes for
dual- scale or No for single scale display
units
Units
Select the display units/tags
rate
Rate
Select the display units for rate
total
Total
Select the display units for total
Gtotal
Grand Total
Select the display units for grand total
Dec pt
Decimal point
Set decimal point for rate, total, grand total
prog
Program
Enter the Program menu
InCAL
Input
Calibration
Enter the Input Calibration menu
sCalE
Scale
Enter the Scale menu
Cal
Calibrate
Enter the Calibrate menu
Inp 1
Input 1
Calibrate input 1 signal or program input 1
value
Dis 1
Display 1
Program display 1 value
Inp 2
Input 2
Calibrate input 2 signal or program input 2
value (up to 32 points)
Dis 2
Display 2
Program display 2 value (up to 32 points)
Error
Error
Error, calibration not successful, check
signal or programmed value
T tb
Total time
base
Program total time base