Operating instructions

2 of 29
Table of Contents
Safety Information ___________
3
Important Information for the User___________________
4
Specifications ___________
5
Introduction ___________
6
Pre Installation Preparations________________________7
Signal Connections___________________________________7
Front Panel Connections __________ ______
8
Preparation for Adjustment___________________________9
Remote Control Operation __________
10
Initial Set Up and Adjustment_______________________11
Focus Adjust Menu ________________
11
Geometry Adjust Menu ________________
13
Convergence Adjustments ________________
17
Gray Scale Adjustment ________________
20
Brightness Adjustment ________________
21
Contrast Adjustment __________
21
Center Convergence __________
21
Centering Adjustments ________________
21
Blanking Adjustments __________
22
Size Adjustments ________________
22
Source Memory Entry __________
22
Global Setup Adjustments __________
23
Power On Control ________________
23
Menu Access ________________
23
Menu time-out __________
24
White Balance Control __________
24
Scan Reversal __________
25
Screen Size Change Procedures ________________
27
Service & Warranty__________________________________
29
WARNING
HAZARDOUS VOLTAGE
DO NOT OPEN
ATTENTION
COURANT ELECTRIQUE
NE PAS OUYRIR
CAN SHOCK, BURN OR CAUSE SEVERE INJURY OR DEATH. DO NOT
REMOVE COVER OR BACK PANEL. REFER SERVICING TO QUALIFIED PERSONNEL.
!
.
DWIN Electronics, Inc.
5838 San Fernando Road Unit D
Glendale, CA 91202
Tel: [phone]
Fax: [phone]
This manual and all information pertaining to circuit
designs, internal operating software and industrial
design are Copyright © by DWIN Electronics Inc.
All Rights Reserved.
Any reproduction or distribution is strictly prohibited.