Installation & Assembly

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
FOR JUNCTION BOX (Fig. 2, if necessary)
9. Secure the mounting ring (D1) to the junction box (F1) using screws (B1). Make sure the two holes (spacing 2-3/4”)
are in a horizontal direction as shown in Fig, 2.
10. Thread the underprop (O1) into the mounting plate (I1) from back.
11. Put the mounting plate (I1) and the conversion plate (P1) onto the mounting ring (D1). Make sure the two holes on mounting
plate (I1), the two slots on conversation plate (P1) and the two holes (spacing 2-3/4”) are aligned. Fasten them using screws (Z1).
12. Place the xture (M1) over the mounting plate (I1) and secure with screws (C1).
INSTALLATION INSTRUCTION
Svelte - dwelLED™
WS-7316, WS-7322, WS-7334
100%10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE ELV DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON MLE03-1
J1
O1 K1
I1
Z1
P1
B1
D1
F1
FIG.2
Junction box
Mounting
ring
Screw
Conversation
plate
Screw
Mounting
plate
Mounting
Anchor
UnderpropWood screw
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring