Installation & Assembly

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
INSTALLATION INSTRUCTION
Svelte - dwelLED™
WS-7316, WS-7322, WS-7334
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture. Including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts on a clear area.
Be careful to lose any small parts necessary for installation.
MOUNTING THE FIXTURE
3. Remove the mounting screws (C1) from the xture.
4. Place the glass (E1) onto the xture back plate (M1). Hold using end cover (H1). Secure with screws (N1) from the xture back
plate (M1) inside.
5. Connect the electrical wires as shown in Fig, 3, making sure that all wire connectors are secured. Fixture and junction box
ground wires should be connected to mounting plate using green screw provided. After wires are connected, tuck them carefully
inside the junction box.
FOR SWITCH BOX (Fig. 1)
6. Drill holes in the wall aligned with the key-hole location in the mounting plate (I1). Insert the mounting anchors (K1).
7. Secure the mounting plate (I1) to the switch box (G1) using screws (B1). The side of the mounting plate marked
“GND” (I1) must face out.
8. Fasten the wood screws (J1) into the mounting anchors (K1). Tighten the mounting plate (I1) on the wall.
A1
G1
B1
C1
I1
K1
J1
M1
N1
H1
E1
FIG.1
Wire connector
Switch box
Screw
Mounting Screw
Mounting plate
Mounting anchors
Wood screw
Fixture back plate
Screw
End cover
Glass