Installation & Assembly

2WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
FIG. 1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (C1) from the xture.
4. Drill holes in the wall aligned with the key holes located in the back plate, insert the plastic anchor (D1).
5. Adjust the xture wire length by pushing the cable grippers on the canopy and pulling the wires as desired.
6. Connect the driver input wires with junction box wires as shown in Fig. 2,
making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture's ground wire
to it. Otherwise, connect the xture's ground wire directly to the mounting
plate using the green screw provided. After wires are connected, tuck them
carefully inside the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
7. Secure the mounting plate to the junction box using junction box screws (B1),
fasten it to the wall using wood screw (E1). The side of the mounting plate
marked "GND" must face out.
8. Place the xture of the mounting plate and secure with mounting screws (C1).
1 5/8"
Wood Screw
Mounting Screw
Plastic Anchor
Wire Connector
Junction Box
Fixture
Back Plate Dimensions
Driver
Junction
Box Screw
Back Plate
B1
E1
C1
D1
A1
INSTALLATION INSTRUCTION
317 - LED Pendant
PD-31727, PD-31735
3 1/2"
8 7/8"