Installation & Assembly

2WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
466 - LED Wall Sconce
WS-46609
C1
A1
D1
B1
Back Plate Dimensions
Junction Box Screw
Wire Connector
Mounting Screw
Glass
Mounting Plate
Back Plate
Driver
Plate Glass
Ground Wire
Junction Box
Mounting Screw
Ground Screw
1 3/4”
1 3/8”
6 5/8”
4”
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
INSTALLATION
3. Remove the mounting screw (B1) from the xture.
4. Connect the driver wire to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box has
a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the back
plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
* Requires Driver to be recessed within the junction box.
MOUNTING
5. Secure the mounting back plate to the junction box using
the junction box screw (C1). The side of the mounting plate
marked “GND” must face out.
6. Insert the glass shade on the mounting plate.
7. Secure the plate glass on the xture with mounting screw (D1).
8. Place the xture on the back plate, and secure it the mounting screw (B1).
FIG.1