Installation & Assembly
Phone (800) 526.2588
Fax (800) 526.2585
44 Harbor Park Drive
Port Washington, NY 11050
1600 Distribution Ct
Lithia Springs, GA 30122
1750 Archibald Avenue
Ontario, CA 91760
2
INSTALLATION INSTRUCTION
WS-W29118
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
3. Remove the mounting screw (B) and
rubber gasket
(C) from the xture.
4. The lamp can switch between three color temperatures (3000K-3500K-4000K), which can be adjusted to your preference with the switch in
the canopy (Fig.4).Set to desired color temperature.
5. Secure the mounting plate to the junction box using standard junction box screws that comes with the junction box.
(i)using any other non-original-manufacturer provided junction box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND” must face out.
6. Connect the xture’s input wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors (A) are secure. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the GND screw provided. After wires are connected, tuck them carefully inside the junction box.
7. Secure the xture to the mounting back plate using the mounting screw (B) and
rubber gasket
(C).
8. To prevent moisture from entering the outlet box and causing a short circuit,use clear caulking (i.e. indoor/outdoor silicone sealant) to
outline the outside of xture back plate where it meets the wall,Leave a space at the bottom to allow moisture to escape(Fig.3).
Black or
Smooth
White or
Ribbed
Bare wire
(Ground)
Black
(Hot)
White
(Neutral)
Green or Bare Copper
(Ground)
3500K4000K
3000K
Mounting Screw
Mounting Plate
B
Junction Box
Wire Connector
A
Fixture
Junction Box Screw
Rubber Gasket
C
Plate Glass
(RPL-GLA-29118)
4"
1 3/4"
4 1/8"
1 3/8"