Installation & Assembly

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Oct 2020
dweLED.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
2
INSTALLATION INSTRUCTION
231 - Outdoor Sconce
WS-W23105
PREPARATION
1. Shut off the power at the circuit breaker and remove existing
xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on
a clear area. Be careful not to lose any small parts necessary
for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (B) and silicone gasket (C) from
the xture.
4. Secure the mounting back plate to the junction box using
standard junction box screws that comes with the junction box.
Note: (i) Using any other non-original-manufacturer provided
junction box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
5. Connect the driver’s input wires to junction box wire as shown in Fig. 2, making sure that all wire connectors (A) are secured. If your outlet
box has a green or bare copper ground wire, connect the xture’s ground wire to it. Oherwise, connect the xture’s ground wire directly
to the mounting plate using the screw provided. After wires are connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION (Fig. 2, 3)
6. Secure the xture to the mounting back plate using the mounting screw (B) and silicone gasket (C).
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking(i.e. indoor/outdoor silicone sealant) to outline
the outside of xture back plate where it meets the wall. Leave a space at the bottom to allow the moisture to escape (Fig. 3).
Fig.1
Green or Bare Copper
(Ground)
House Wires
White
(Neutral)
House Wires
Black
(Hot)
House Wires
Fig.2 Wiring
Bare Wire
(Ground)
Fixture Wires
White or
Ribbed
Fixture Wires
Black or
Smooth
Fixture Wires
Caulking
Junction Box
Fig.3 Sealing
Junction Box
Mounting Back Plate
Junction Box Screw
Ground Wire
A
Wire Connector
Driver
Mounting Screw
B
Silicone Gasket
C
Fixture
Mounting Backplate Dimensions
4
1
8
"
4
3
8
"
Ø2
3
4
"
Ø3
1
2
"