Installation manual
IOI-XTRK-10D Installation Manual
iv
1 Document Information
Document Scope and Purpose
The purpose of this document is to provide instructions and installation procedures for physically
connecting the IOI-XTRK-10D encoder. After completing the physical installation, additional setup
and configurations are required before video analysis and detection can commence.
For information on the unit setup and configuration, refer to the HTML Edition Units User’s Guide.
Note:
This document is intended for use by technical users who have a basic
understanding of CCTV camera/video equipment and LAN/WAN network
connections.
Warning:
Installation must follow safety, standards, and electrical codes as well as the laws
that apply where the units are being installed.
Proprietary Rights and Non-Disclosure
This manual is delivered subject to the following restrictions and conditions:
This document contains proprietary information belonging to DVTEL, Inc. This
information is supplied solely for the purpose of assisting explicitly the licensee
of the DVTEL units.
No part of this document contents may be used for any other purpose, disclosed
to any third party or reproduced by any means, electronic or mechanical, without
the express prior written permission of DVTEL, Inc.
Trademarks and Copyrights
DVTEL, the DVTEL logo, ioimage, the ioimage logo, ioimage analytics, ioibox, ioicam, ioiware, ioiware
command center, ioiware setup, CP-2202-361P/N, IOI-XTRK-10D, IOI-XTRK-100D, trk1, trk10d,
trk100, trk100d, trk-101, trk200, trk4000d, trk8000, mmp100dn, sc1dn-A, XPVA-10D, and XPVA-
100D are trademarks of DVTEL, Inc.
Products and trademarks mentioned herein are for identification purposes only and may be
registered trademarks of their respective companies.
DVTEL, Inc. makes no representations whatsoever about any other products or trademarks
mentioned in the manual.
This manual and its contents herein are owned by DVTEL, Inc.
© 2013 DVTEL, Inc. All rights reserved.