Installation manual

Appendix

A.2. Connecting Leads to a Spring Clamp Terminal Block

The encoder comes with two terminal block connectors. Each connector is for terminating wires and

then plugging the connector into the relay output of the encoder.

Figure 12 - Installed Terminal Block Connector

To connect a wire to the spring clamp terminal block

1. Strip the insulation form the end of each wire that is to be connected to the terminal

block. Approximately 1 cm (2.54”) of wire should be exposed.

2. With a small screwdriver, press in and hold the orange spring clamp button next to the

female outlet where the wire will be inserted.

3. Insert the stripped end of the wire into the female outlet.

4. Release the orange spring clamp button.

Figure 13 - Connecting a Wire to a Terminal Block