Installation manual

Connections and Configuration
21
To reset a board using the RESET button
1. Insert a small pointed object into the hole labeled RESET on the front panel of the unit.
2. Press in and release. The unit resets to the previous settings.
5.4.2 Reset by Removing the Power Supply
The unit can be reset by turning off the power and then turning it on again.
To reset a unit by removing the power supply
1. Turn off or disconnect the power to the unit.
2. Turn on or reconnect the power to the unit. The unit restarts with the previous settings.
Solo Setup 5.5
The Solo Setup function enables you to install and setup a camera at the remote site without
requiring another person’s assistance. With this function, you can:
 Use the camera to record a set of snapshots of the scene while the user is moving around
the camera field of view
 Move around within the camera’s field of view
 Use the recording of his movement to setup the depth by marking his height on the
camera’s field of view.
For instructions on how to use the Solo Setup function, see page 26 in the Appendix.